Home >

Brief Description Of Rubber Processing Operation Procedures

2010/3/29 13:22:00 75

I. safety regulations for artificial rubber cutting

One

Before operation, carefully check oil level, electric limit switch, pmission device and hydraulic system, keep the glue cutting machine in good condition, and the glue cutting machine must be equipped with series double switch device.

Two

And trolley pportation shall not exceed the limit specified by our factory.

Three

It is necessary to use iron hooks when cutting glue.

Four

When the glue is placed, the raw rubber can be activated before starting. After starting, the rubber block should be prevented from popping and hurting people. No part of the body should be crossed over the cutter line when cutting.

Do not use hand and foot to promote raw rubber when cutting glue knife.

Five

It is forbidden to cut glue continuously, prohibit cutting cold, hard raw rubber and sundries.

Six

When the equipment is running, it is forbidden to crawl or lie down on the conveyor belt.

Seven

When facing the blade of the knife edge, the cutting knife raises the wooden block and can be carried out after cutting off the power supply.

Eight

When discontinued, the cutter should be lowered, cut off the power supply and clean up the site.

Two. Safe operation procedures for automatic glue cutting.

One

Observe the safety regulations of artificial glue cutting.

Two

The automatic glue cutting personnel should contact the scale personnel of the corresponding machine before carrying out the operation.

Three. Safety operation rules for gel breaker

One

On the belt, strictly prohibit crossing, crawling, lying and waiting, so as to prevent hurting people.

Two

The conveyor belt must be conveyer. The conveyor belt must be stopped when it is stopped and stopped. When rubber is conveyer, it is necessary to prevent the rubber from being crushed.

Three

When the gel is broken, it is necessary to prevent the rubber from popping and hurting people. When the roller is not easy to roll down the rubber, it must be handled with special tools.

Four

And others

((

Safety operation regulations for open rubber mixing machine.

Four.

XHM

Safety operation rules for series mixer

One

Before working, wear protective clothing and special respirator and respirator.

Two

Before running, it is necessary to check the rotors in the mixing room to ask if there are any sundries, top and bottom bolts, turn over doors, meters, signal devices and so on.

Three

Before you drive, you must send a signal. You can only drive when you hear that it is confirmed that there is no danger.

Four

Before placing the material, close down the top bolt first and put the film in one by one. Strictly prohibit the feeding at a time. The powder should be put lightly to light, and the carbon black bag must be delivered downward to the wind pipe.

Five

During the operation of the equipment, it is strictly prohibited to view the probe in the mixing chamber. When watching, you must hook up the feeding port with the hook, lift the top bolt and insert the safety pin before you can view it.

Six

During operation, it is found that debris must be shut down when it goes out of the mixing room or fails.

Seven

In case of a sudden stop, the upper bolt should be lifted and inserted into the safety pin to open the lower plug, cut off the power supply, and turn off the water and steam valves.

If you use manual rotary coupling to discharge material, pay attention to cooperate with each other and strictly prohibit driving with materials.

Eight

Upper top bolt is extruded with rubber.

(

card

)

When you live, you must stop.

Nine

The material leaking out of the bottom bolt is not allowed to be pulled by hand, and must be removed by iron hook.

Ten

When operating, it is necessary to stand outside the feeding and turnover board, and not to stand in the lower part of the discharging port.

Eleven

We should be careful when using materials and vehicles. When pporting materials, we should gently handle them and prevent them from hurting people.

Twelve

It should be connected with the next process by signal.

Thirteen

After parking, insert safety pin, close the flap door, lower the top bolt, open the lower plug, close the wind, water and steam valve, and cut off the power supply.